Audio Valve Sunilda Phono Amp
A view of the compact and absolute wireless electronic - riaa modul from SUNILDA. There is no hum, bee or any noise - only music. The design on a double side pc board is constructed in double mono technology, use best and selected components and guarantee high stable and highend vinyl re - productions.
Product Description  
Sundila is a three stage phono-preamplifier, based on 6922 (ECC88) and  12AX7 (ECC83) frame grid tubes, suitable for two MM- and MC-cartridges at the same time. Independently for the two phono inputs, impedance and capacitive load can be set separately and 'on-the -fly' while listening. Thus the user can easily configure the unit to match the features of the cartridge by selecting the optimal input resistance and capacitance for each input separately!
Switches in front are found for: MM/MC mode for each input; input 1 or 2; selectors are used to select different resistor and capacitive input loads.
In MM mode the gain will be 23 dB lower than MC and at a fixed input-impedance of 47 K.
In MC mode the preamp will have 20 dB higher gain and switchable input resistors and condensers. The RIAA de-emphasis is passive and split between the first and second stage. Dividing the RIAA network over two amplification stages lowers the insertion losses of the passive network dramatically. Furthermore, the design holds a total absence of feedback, thus increasing the overall dynamics.
Power supplies are solid state regulated. This is the best way to obtain a low noise and supply line with a very low impedance that will increase the performance in the lower frequency range. The power transformer is housed in a separate aluminum case.
Sunilda comes in an lasercut, 3mm thick steel, chassis in black or silver finish and has a case similar to the Eklipselineamplifier.

function selectors at the SUNILDA frontpanel for different modes and cartrigdes ( MM / MC )

Separate resistor - impedance and capacitive selector for every input

It is, therefore, physically impressive for a phono stage in terms of bulk and heft, more in keeping with the Audio Research PH5 and other 'full size' units than the typically cigarette-pack-sized offerings. Blessedly, it eschews minimalism because the Sunilda is clearly aimed at the vinyl addict, the sort of audiophile with more than one turntable and a herd/coven/school/flock of cartridges. For this alone, it raised the hairs on my neck. However much I worship the PH5, there are times when I find its lack of facilities limiting. (Then again, I'm a reviewer as well as vinyl addict, and I do change cartridges frequently.)
DIP switch for SUB - SONIC selection
Helmut Becker likes wireless assembly, so the guts of the Sunilda rest on a double-sided PC board, laid out in a dual-mono topology, all beautifully assembled. Becker doesn't compromise on the components, and he indulges in hand-selection, so the see-through lid is no conceit: you'll enjoy gazing at its innards. For hours.
He describes the Sunilda as a 'three-stage phono-preamplifier, based on 6922 or ECC88 and 12AX7 or ECC83 frame grid tubes.' The Sunilda - named after the daughter of Siegfried and Brunhilde, so Valkyries can wallow in this one - accommodates both moving magnet and moving-coil cartridges. What inveterate fiddlers will love is that the Sunilda is two complete phono stages in one, with BOTH sets of inputs enjoying the full complement of settings, unlike some that offer either m-m or m-c for one or the other inputs. Where this might prove handy is for A/B'ing arms or turntables when you would need to use the same cartridges in both. And if you had two identical turntable/arm set-ups, you could use it to compare cartridges, including two of the same make and model. (Ask Decca-fiends about sample-to-sample variation...) And if you have two identical turntable/arm/cartridges, well, how about A/B'ing different LP pressings. Like 180g vs 200g or reissue vs original?
Thus, you have, independently for the two inputs, adjustable impedance and capacitive load, which you can do 'on-the-fly' while listening. Across the front, you have four rotaries and four toggle switches. The rotaries, two per input, set capacitance of 0, 100, 220 or 470pf and impedance of 47, 100, 220, 470, 1k and 47k ohms. Note that in moving magnet mode, the gain is 20dB lower than in m-c mode, at a fixed input-impedance of 47k.This means that users who like their m-cs at 47k ohms can employ that value with some added gain. Koetsu users: rejoice!
As for the four toggles, accompanied by various coloured LEDs, they activate, left to right, mute/operate/standby, mm/mc select for input 1, input selector for input 1 or 3, and lastly mm/mc select for input 2. Around the back are the two sets of RCA phono inputs with separate earths, a single pair of RCA phono outputs and the socket for the power supply.
Sunilda's RIAA de-emphasis is passive and split between the first and second stage. According to Becker, 'Dividing the RIAA network over two amplification stages lowers the insertion losses of the passive network dramatically. Furthermore, the design has a total absence of feedback, thus increasing the overall dynamics.' He also opted for solid-state regulated power supplies. 'This is the best way to obtain low noise and a supply line with a very low impedance, to increase the performance in the lower frequency range.'
Other niceties include an outboard power supply, housed in a separate aluminium case and connecting to the main chassis with a computer-grade cable. The main case itself is laser-cut, 4mm thick steel, as mentioned before absolutely identical in size to the Eklipse line-level pre-amplifier. Beside offering the Sunilda in both silver and black, you can also specify silver or gilt knobs, again depending on your stomach for bling-bling. Alas, Sunilda sunglass are not supplied.
This unit arrived in the midst of my most overactive analogue phase in years. In addition to SME 10 and SME 30 turntables, I've recently added a Trio L-07D, and I have a fistful of cartridges to play with, and of every stripe: London Gold and Maroon (the latter mono), Koetsu Black Urushi, Shure V15 V, Lyra (mono) Dorian, Transfiguration Temper V and a few others. With this mix, I was able to assess most of the settings, comparing m-m vs m-c, assorted impedances and other characteristics. First, some observations:
If you are using a complex system, and a couple of turntables, you must pay attention to earthing to avoid a loop. You may find yourself opening AC plugs to disconnect earths. Moreover, the Sunilda responds well to quality mains leads, a solid mounting surface and a good set of phono cables to the pre-amp, which in this case was a line input on the McIntosh C2200. I used Transparent Reference, and did not earth the Sunilda to the Mac. The rest of the system included the McIntosh MC2102 and Wilson WATT Puppy System 7.
What was common at all stages was a consistency that shows Becker favoured neither mm nor m-c: the Sunilda treats both equally. Where it shines is in its ability to let the user extract the most from either. I know, there are phono stages that provide even more settings, but AudioValve struck a nice balance. The only thing I would have added were oddball impedances for mm so I could tweak the Deccas, but then I've only ever found these on Tim De Paravicini's magnificent solid-state EAR 324.
Provided you address the cabling properly, the Sunilda is eerily quiet, if not quite on a par with the Sutherland Phd. And yet you never forget that it's all-valve, with a warmth that separates it from the EAR 324. The latter is hardly 'cold', but it is so precise and proper that it approaches 'laboratory equipment' in its presentation. The Sunilda is definitely fatter, more . Intriguingly, transparency is on a par with solid-state phono stages, so either Becker found some top-grade tubes, or - more likely - he extracted better performance from the glassware he used than is humanly possible, something he does with his power amps. (Actually, for Sunilda he's using Electro-Harmonix tubes, which are mighty fine.)
Sunilda's warmth was kept in check so that it didn't overwhelm the listener with a hyper-analogue sound. It's easy to dial in so much euphonic artifice that you can make any LP sound more inviting than most intrinsically harsh digital sources, but that means throwing away super-quick transients, or bass slap. Sunilda sacrifices nothing: it pours forth the detail, the air, the sense of a three-dimensional space and the kind of control that's hard to fault. If, on the other hand, you need a vice-like grip over the entire affair, you simply have to turn to EAR. (Damn, that 324 is some kind of wonderful...)
What made me fall in love with the Sunilda were big band mono LPs, which possess a sheen and shimmer that exists nowhere else. Trust me: Billy May LPs have to be heard in true mono. With both the Decca Maroon and the Lyra Dorian, I was able to summon up room-filling, ear-caressing sounds that can only be described as 'silky'. I hope that analogue's leading warriors, Michaels Hobson and Fremer in the USA, get hold of Sunildas, because Sunilda will prove to be a positively Wagnerian ally. If you have any doubts about the worth of vinyl in 2005, this phono stage will help dispel them.
As you can imagine, competition in this sector is tough: really, really tough. I recently bought the Audio Research PH5, and - love it though I truly do - I have to admit that it's shy of adjustability, and lacks the facility for a second turntable; this makes it a pain in the arse if you like to fiddle about with cartridges and decks. Conversely, it's THE choice if you <DON'Tfiddle around. EAR's phono offerings are always magical, from the least expensive to the sublimely dear; Quad's new valve phono amp is even more of a bargain than the Sunilda; Sutherland's Phd is the quietest phono stage I've ever heard (to be reviewed soon!). As any show-goer will tell you, there are countless other superb phono amps to consider as well. Sunilda, however, is something genuinely special: it combines the best balance of all of the above phono amps' virtues, sonically and practically, then doubles them up and sells them to you for a sane price.
But take a tip from KK: order yours in silver rather than black.
Technical Specifications:
Gain: MM 41dB, MC 63dB ( 1Khz )
Input selectable LOAD resistors: 47 R,    100 R,    220 R,    470 R,    1 K,    47 K ( for MM only ) 
Input selectable LOAD capacitors:  0 p,    100 p,     220 p,    470p,    1000p,    0 p
Frequency Response: 20Hz to 65 KHz +/- 3 dB
Subsonic filter roll-off: 20 Hz
Max output amplitude: 14V pk
RIAA accuracy max.: +/- 0,18dB
Distortion: MM 0,24 %, MC 0,32% (1Khz - 2V out)
Noise: MM - 63dB, MC - 73dB
Circuit type: 3 stages single ended, buffered ouputs
RIAA network: passive 
Tubes: 2 x 6922 (6N1P),   2 x 12AX7
mode functions: Stand - by and mute functions
Power supplies: high accuray solid state regulated
Power transformer: outside housed and shielded
Power requirements: 115/230 - 245 Ac - 50/60Hz
Powerconsumption: Watts: 50 VA
Dimensions:   cm, W x H x D :42 * 32 * 14 (same as Eklipse)
Weight:  Kg: 20 kg


Sound Of Strings 絃聲音響 © 2020